Configuring Interfaces For Layer 2 Mode - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

Configuring Interfaces for Layer 2 Mode

All interfaces on all switches that participate in spanning tree must be in Layer 2 mode and enabled.

Figure 130. Example of Configuring Interfaces for Layer 2 Mode

To configure and enable the interfaces for Layer 2, use the following command.

If the interface has been assigned an IP address, remove it.

INTERFACE mode

no ip address

Place the interface in Layer 2 mode.

Spanning Tree Protocol (STP)