Port Numbering - Dell C9000 Series Networking Configuration Manual

Port Numbering

On the C9010, linecard slots are numbered 0 to 9. The RPM slots are numbered 10 and 11.
NOTE: If the C9010 operates with only one RPM, you can install the RPM in either slot 10 (the top RPM
slot labeled R0) or slot 11 (the bottom RPM slot labeled R1). If you install two RPMs, by default, the RPM in
slot 10 is the primary management unit and the RPM in slot 11 is the standby. In software command
output, the RPM in slot 10 (R0) is displayed as rpm0; the RPM in slot 11 (R1) is displayed as rpm1
Figure 47. C9010 Slot Numbering
To configure a C9010 port, specify the interface with the command syntax:
interface {TenGigabitEthernet | fortyGigE} slot/port-number
• The slot is a chassis slot number from 0 to 11.
• port-number is a linecard port number from 0 to 23 or an RPM port number from 0 to 3.
NOTE: For slots 10 and 11, the port number is from 0 to 3 only.
Interfaces 492