Dell C9000 Series Networking Configuration Manual page 595

Example of Viewing IS-IS Metric Types
Dell#show isis protocol
IS-IS Router: <Null Tag>
System Id: EEEE.EEEE.EEEE IS-Type: level-1-2
Manual area address(es):
47.0004.004d.0001
Routing for area address(es):
21.2223.2425.2627.2829.3031.3233
47.0004.004d.0001
Interfaces supported by IS-IS:
Vlan 2
GigabitEthernet 4/22
Loopback 0
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics:
Generate wide metrics:
Accept wide metrics:
Dell#
Configuring the IS-IS Cost
When you change from one IS-IS metric style to another, the IS-IS metric value could be affected. For each
interface with IS-IS enabled, you can assign a cost or metric that is used in the link state calculation.
To change the metric or cost of the interface, use the following commands.
• Assign an IS-IS metric.
INTERFACE mode
isis metric default-metric [level-1 | level-2]
• default-metric: the range is from 0 to 63 if the metric-style is narrow, narrow-transition, or
transition.
The range is from 0 to 16777215 if the metric style is wide or wide transition.
• Assign a metric for an IPv6 link or interface.
INTERFACE mode
isis ipv6 metric default-metric [level-1 | level-2]
• default-metric: the range is from 0 to 63 for narrow and transition metric styles. The range is
from 0 to 16777215 for wide metric styles.
The default is 10.
The default level is level-1.
For more information about this command, refer to
The following table describes the correct value range for the isis metric command.
Metric Sytle Correct Value Range
wide 0 to 16777215
narrow 0 to 63
level-1-2
none
none
Configuring the IS-IS Metric
Intermediate System to Intermediate System
Style.
595