Using Scp With Ssh To Copy A Software Image - Dell C9000 Series Networking Configuration Manual

hostname is the IP address or host name of the remote device. Enter an IPv4 or IPv6 address in dotted
decimal format (A.B.C.D).
• Configure the Dell Networking system as an SCP/SSH server.
CONFIGURATION mode
ip ssh server {enable | port port-number}
• Configure the Dell Networking system as an SSH server that uses only version 1 or 2.
CONFIGURATION mode
ip ssh server version {1|2}
• Display SSH connection information.
EXEC Privilege mode
show ip ssh
Specifying an SSH Version
The following example shows using the ip ssh server version 2 command to enable SSH version 2
and the show ip ssh command to confirm the setting.
ell(conf)#ip ssh server version 2
Dell(conf)#do show ip ssh
SSH server
SSH server version
SSH server vrf
SSH server ciphers
ctr,aes128-cbc,3des-cbc.
SSH server macs
md5-96.
SSH server kex algorithms : diffie-hellman-group-exchange-sha1,diffie-hellman-
group1-sha1,diffie-hellman-group14-sha1.
Password Authentication
Hostbased Authentication
RSA Authentication
Vty Encryption
Dell(conf)#
To disable SSH server functions, use the no ip ssh server enable command.

Using SCP with SSH to Copy a Software Image

To use secure copy (SCP) to copy a software image through an SSH connection from one switch to another,
use the following commands.
1 On Switch 1, set the SSH port number (port 22 by default).
CONFIGURATION mode
ip ssh server port number
2 On Switch 1, enable SSH.
CONFIGURATION mode
ip ssh server enable
3 On Switch 2, invoke SCP.
: enabled.
: v1 and v2.
: default.
: aes256-ctr,aes256-cbc,aes192-ctr,aes192-cbc,aes128-
: hmac-sha2-256,hmac-sha1,hmac-sha1-96,hmac-md5,hmac-
: enabled.
: disabled.
: disabled.
HMAC Remote IP
Security 1001