Dell C9000 Series Networking Configuration Manual page 467

information is de-registered. The Leave timer must be greater than or equal to 3x the Join timer. The
default is 600ms.
• LeaveAll — After startup, a GARP device globally starts a LeaveAll timer. After expiration of this interval, it
sends out a LeaveAll message so that other GARP devices can re-register all relevant attribute
information. The device then restarts the LeaveAll timer to begin a new cycle. The LeaveAll timer must
be greater than or equal to 5x of the Leave timer. The default is 10000ms.
Example of the garp timer Command
Dell(conf)#garp timer leav 1000
Dell(conf)#garp timers leave-all 5000
Dell(conf)#garp timer join 300
Verification:
Dell(conf)#do show garp timer
GARP Timers Value (milliseconds)
----------------------------------------
Join Timer 300
Leave Timer 1000
LeaveAll Timer 5000
Dell(conf)#
The system displays this message if an attempt is made to configure an invalid GARP timer:
Dell(conf)#garp timers join 300 % Error: Leave timer should be >= 3*Join timer.
GARP VLAN Registration Protocol (GVRP) 467