Specifying A Default Gateway; Configure A Method Of Hostname Resolution - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

Creating Manual Binding Entries

Debugging the DHCP Server

Using DHCP Clear Commands

Excluding Addresses from the Address Pool

The DHCP server assumes that all IP addresses in a DHCP address pool are available for assigning to DHCP

You must specify the IP address that the DHCP server should not assign to clients.

To exclude an address, follow this step.

Exclude an address range from DHCP assignment. The exclusion applies to all configured pools.

excluded-address

Specifying an Address Lease Time

To specify an address lease time, use the following command.

Specify an address lease time for the addresses in a pool.

DHCP <POOL>Mode

lease {days [hours] [minutes] | infinite}

The default is 24 hours.

Specifying a Default Gateway

The IP address of the default router should be on the same subnet as the client.

To specify a default gateway, follow this step.

Specify default gateway(s) for the clients on the subnet, in order of preference.

DHCP <POOL>Mode

default-router address

Dell Networking systems are capable of providing DHCP clients with parameters for two methods of

hostname resolution—using DNS or NetBIOS WINS.

Dynamic Host Configuration Protocol (DHCP)