Configuring The Minimum Oper Up Links In A Port Channel - Dell C9000 Series Networking Configuration Manual

no channel-member interface
2 Change to the second port channel INTERFACE mode.
INTERFACE PORT-CHANNEL mode
interface port-channel id number
3 Add the interface to the second port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
Example of Moving an Interface to a New Port Channel
The following example shows moving the TengigabitEthernet 1/8 interface from port channel 4 to port
channel 3.
Dell(conf-if-portch)#show config
!
interface Port-channel 4
no ip address
channel-member TengigabitEthernet 1/8
no shutdown
Dell(conf-if-portch)#no chann te 1/8
Dell(conf-if-portch)#int port 5
Dell(conf-if-portch)#channel te 1/8
Dell(conf-if-portch)#show conf
!
interface Port-channel 5
no ip address
channel-member TengigabitEthernet 1/8
shutdown
Dell(conf-if-portch)#
Configuring the Minimum Oper Up Links in a
Port Channel
You can configure the minimum links in a port channel (LAG) that must be in "oper up" status to consider the
port channel to be in "oper up" status.
To set the "oper up" status of your links, use the following command.
• Enter the number of links in a LAG that must be in "oper up" status.
INTERFACE mode
minimum-links number
The default is 1.
Example of Configuring the Minimum Oper Up Links in a Port Channel
Dell#config t
Dell(conf)#int po 1
Dell(conf-if-po-1)#minimum-links 5
Dell(conf-if-po-1)#
Interfaces 519