Enabling And Disabling A Port Using Snmp - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

F10-ISIS-MIB::f10IsisSysOloadV6WaitForBgp

To enable overload bit for IPv4 set 1.3.6.1.4.1.6027.3.18.1.1 and IPv6 set

1.3.6.1.4.1.6027.3.18.1.4

To set time to wait set 1.3.6.1.4.1.6027.3.18.1.2 and 1.3.6.1.4.1.6027.3.18.1.5

respectively

To set time to wait till bgp session are up set 1.3.6.1.4.1.6027.3.18.1.3 and

1.3.6.1.4.1.6027.3.18.1.6

Enabling and Disabling a Port using

To enable and disable a port using SNMP, use the following commands.

Create an SNMP community on the Dell system.

CONFIGURATION mode

snmp-server community

From the Dell Networking system, identify the interface index of the port for which you want to change

the admin status.

EXEC Privilege mode

show interface

Or, from the management system, use the snmpwwalk command to identify the interface index.

Enter the snmpset command to change the admin status using either the object descriptor or the OID.

snmpset with descriptor: snmpset -v version -c community agent-ip

ifAdminStatus.ifindex i {1 | 2}

snmpset with OID: snmpset -v version -c community agent-ip .

1.3.6.1.2.1.2.2.1.7.ifindex i {1 | 2}

Choose integer 1 to change the admin status to Up, or 2 to change the admin status to Down.

Simple Network Management Protocol (SNMP)

Troubleshooting