Dell C9000 Series Networking Configuration Manual page 331

-----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 1
Acknowledgment Number: 1
Protocol State: In-Sync
Peer DCBx Status:
----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 1
Acknowledgment Number: 1
Total DCBx Frames transmitted 994
Total DCBx Frames received 646
Total DCBx Frame errors 0
Total DCBx Frames unrecognized 0
The following table describes the show interface DCBx detail command fields.
Table 22. show interface DCBx detail Command Description
Field
Interface
Port-Role
DCBx Operational Status
Configuration Source
Local DCBx Compatibility mode
Local DCBx Configured mode
Peer Operating version
Local DCBx TLVs Transmitted
Local DCBx Status: DCBx Operational Version
Local DCBx Status: DCBx Max Version Supported
Local DCBx Status: Sequence Number
Description
Interface type with chassis slot and port number.
Configured DCBx port role: auto-upstream, auto-
downstream, config-source, or manual.
Operational status (enabled or disabled) used to elect
a configuration source and internally propagate a
DCB configuration. The DCBx operational status is
the combination of PFC and ETS operational status.
Specifies whether the port serves as the DCBx
configuration source on the switch: true (yes) or false
(no).
DCBx version accepted in a DCB configuration as
compatible. In auto-upstream mode, a port can only
received a DCBx version supported on the remote
peer.
DCBx version configured on the port: CEE, CIN, IEEE
v2.5, or Auto (port auto-configures to use the DCBx
version received from a peer).
DCBx version that the peer uses to exchange DCB
parameters.
Transmission status (enabled or disabled) of
advertised DCB TLVs (see TLV code at the top of the
show command output).
DCBx version advertised in Control TLVs.
Highest DCBx version supported in Control TLVs.
Sequence number transmitted in Control TLVs.
Data Center Bridging (DCB) 331