back-up destination {ip address ipv4-address/mask | ipv6 address ipv6-address/
mask}
Dell(conf-vlt-domain)#back-up destination ?
A.B.C.D
ipv6
IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of the VLT peer's management interface.
5
Repeat Steps 1 – 4 on the VLT peer switch.
To set the amount of time, in seconds, to delay the system from restoring the VLT port, use the delay-
restore command at any time. For more information, refer to
Configuring a VLT Port Delay Period
To configure a VLT port delay period, use the following commands.
1
Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs from 1 to 1000.
2
Enter an amount of time, in seconds, to delay the restoration of the VLT ports after the system is
rebooted.
CONFIGURATION mode
delay-restore delay-restore-time
The range is from 1 to 1200.
The default is 90 seconds.
Reconfiguring the Default VLT Settings
(Optional)
To reconfigure the default VLT settings, use the following commands.
1
Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
2
(Optional) When you create a VLT domain on a switch, the system automatically creates a VLT-system
MAC address used for internal system operations.
VLT DOMAIN CONFIGURATION mode
IP address for VLT backup link
Configure IPv6 address for VLT backup link
VLT Port Delayed
Restoration.
Virtual Link Trunking (VLT)
1184