Dcbx Prerequisites And Restrictions; Configuring Dcbx - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:
Table of Contents

Advertisement

DCBx Prerequisites and Restrictions

The following prerequisites and restrictions apply when you configure DCBx operation on a port:
For DCBx, on a port interface, enable LLDP in both Send (TX) and Receive (RX) mode (the protocol
lldp mode command; refer to the example in
the
Link Layer Discovery Protocol (LLDP)
DCBx interface, LLDP is shut down.
The CIN version of DCBx supports only PFC, ETS, and FCOE; it does not support iSCSI, backward
congestion management (BCN), logical link down (LLDF), and network interface virtualization (NIV).

Configuring DCBx

To configure DCBx, follow these steps.
For DCBx, to advertise DCBx TLVs to peers, enable LLDP. For more information, see
Link Layer Discovery Protocol
Configure DCBx operation at the interface level on a switch or globally on the switch.
1
Configure ToR- and FCF-facing interfaces as auto-upstream ports.
2
Configure server-facing interfaces as auto-downstream ports.
3
Configure a port to operate in a configuration-source role.
4
Configure ports to operate in a manual role.
NOTE:
The DCBx configuration is not supported on cascade interfaces or extended ports
1
Enter INTERFACE Configuration mode.
CONFIGURATION mode
interface type slot/port
2
Enter LLDP Configuration mode to enable DCBx operation.
INTERFACE mode
[no] protocol lldp
3
Configure the DCBx version used on the interface, where: auto configures the port to operate using the
DCBx version received from a peer.
PROTOCOL LLDP mode
[no] DCBx version {auto | cee | cin | ieee-v2.5}
cee: configures the port to use CEE (Intel 1.01).
cin: configures the port to use Cisco-Intel-Nuova (DCBx 1.0).
ieee-v2.5: configures the port to use IEEE 802.1Qaz (Draft 2.5).
The default is Auto.
4
Configure the DCBx port role the interface uses to exchange DCB information.
PROTOCOL LLDP mode
[no] DCBx port-role {config-source | auto-downstream | auto-upstream | manual}
CONFIGURATION versus INTERFACE Configurations
chapter). If multiple DCBx peer ports are detected on a local
(LLDP).
Data Center Bridging (DCB)
in
317

Advertisement

Table of Contents
loading

Table of Contents