Table of Contents
Advertisement
PDU Counters
Additional counters for various types of PDUs that are sent and received from neighbors are also supported.
These are seen in the output of the show ip bgp neighbor command.
Sample Configurations
The following example configurations show how to enable BGP and set up some peer groups. These
examples are not comprehensive directions. They are intended to give you some guidance with typical
configurations.
To support your own IP addresses, interfaces, names, and so on, you can copy and paste from these
examples to your CLI. Be sure that you make the necessary changes.
Border Gateway Protocol IPv4 (BGPv4)
250
Advertisement
Table of Contents
Troubleshooting
