Dell C9000 Series Networking Configuration Manual page 848

• interface interface-type specifies a C9010 10-Gigabit Ethernet interface. The only
supported value is TenGigabitEthernet slot/port-range.
• slot/port-range specifies a C9010 10GbE port, including slot number and either a single port
number, a port range, or a combination of both for auto-LAG configuration.
• The range of slot numbers is from 0 to 9 for linecard slots. The range of port numbers is from 0 to
23.
• Enter a port range with or without spaces; for example, cascade interface
tengigabitethernet 0/1-5 or cascade interface tengigabitethernet 0/1 - 5.
• You can enter up to six comma-separated ranges or port numbers; for example, cascade
interface tengigabitethernet 0/1-2,8,10–12,15.
4 Enable the C9010 cascade ports.
CONFIGURATION mode
interface tengigabitethernet slot/port-range
INTERFACE CONFIGURATION mode
no shutdown
Example of Configuring a PE Stack
NOTE: Dell Networking OS recommends not to use RPM Slots 10 and 11 for PE connectivity.
Dell(conf)# feature extended-bridge
Dell(conf)# pe provision 2
Dell(conf-pe-2)# cascade interface tengigabitethernet 0/0-1
Dell(conf-pe-2)# exit
Dell(conf)# interface range tengigabitethernet 0/0-1
Dell(conf-if-range-te-0/0-1)# no shutdown
Dell(conf-if-range-te-0/0-1)# end
Dell# show pe 2
Codes: A - Active, I - Inactive
Reason: CTM - Card Type Mismatch, CAM - CAM ACL Mismatch
SVM - Software Version Mismatch, UE - Unknown Error
Offline Reason: UNP - Unit Not Present,
ICE - IPC CP Error, IRE - IPC RP Error
ISE - IPC Setup Error, CVE - CHM Validation Error
PE-ID assigned: 0
Status: online
System Mac: a0:68:00:3f:92:bc
PE Up Time: 14:06:37
PE Discovery Status: Provisioned PE
User Configured Cascade Ports: Te 0/0(A),Te 0/1(A)
Cascade LAG: Po 258(Up)
---------------------------------------------------------------
Stack-id Status
---------------------------------------------------------------
0 online
1 online
2 online
Example of Dual Homed PE Stack
Dell(conf-b)#pe provision 2
Dell(conf-b-pe-2)#cascade interface TenGigabitEthernet 0/0
Dell(conf-b-pe-2)#cascade interface TenGigabitEthernet 1/4 peer
Reason Type
- C1048P a0:68:00:3f:92:bc
- C1048P 6c:c0:00:11:22:33
- C1048P 34:17:eb:00:bb:09
UnitMac No. of Ports
Port Extender (PE) Stacking
52
52
52
848