Port Extender Interfaces - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:

Table of Contents

Configure an IP address.

INTERFACE mode

Enable the interface.

INTERFACE mode

The interface is the management interface.

INTEFACE mode

Example of the show interface and show ip route Commands

To display the configuration for a given port, use the show interface command in EXEC Privilege mode, as

shown in the following example. To display the routing table, use the show ip route command in EXEC

Privilege mode.

Dell#show int fortyGigE 2/12

fortyGigE 2/12 is up, line protocol is up

Hardware is DellEth, address is 74:86:7a:ff:6f:48

Current address is 74:86:7a:ff:6f:48

Pluggable media present, QSFP type is 40GBASE-CR4-1M

Interface index is 154288642

Internet address is 6.1.1.1/24

Mode of IPv4 Address Assignment : MANUAL

[output omitted]

Dell#show ip route

Codes: C - connected, S - static, R - RIP,

B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,

O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,

N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,

E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,

L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,

> - non-active route, + - summary route

Gateway of last resort is not set

Port Extender Interfaces

You can use a C9010 switch with an attached C1048P port extender (PE) to expand the port density of the

chassis. In this configuration, the C9010 operates as a controlling bridge for the C1048P. The C1048P

functions as a remote line card that is physically connected to, and automatically provisioned by, a C9010

over 10GE links according to the IEEE 802.1BR standard.

Direct, Fo 2/12

Direct, Vl 10

via 6.1.1.1,

Dist/Metric Last Change

----------- -----------