Dell C9000 Series Networking Configuration Manual page 329

Field
Local Parameters
Operational status (local port)
ETS DCBx Oper status
State Machine Type
Conf TLV Tx Status
ETS TLV Statistic: Input Conf TLV pkts
ETS TLV Statistic: Output Conf TLV pkts
ETS TLV Statistic: Error Conf TLV pkts
The following example shows the show linecard 2 port-set 0 backplane all pfc details
command.
Dell#show linecard 2 port-set 0 backplane all pfc details
2 port-set 0 backplane all
Admin mode is On
Admin is enabled, Priority list is 3
Local is enabled, Priority list is 3
Link Delay 65535 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
The following example shows the show linecard 2 port-set 0 backplane all ets details
command.
Dell#show linecard 2 port-set 0 backplane all ets details
linecard 2 port-set 0 backplane all
Max Supported PG is 3
Number of Traffic Classes is 8
Admin mode is on
Description
Willing bit received in ETS TLVs from the remote peer
is included.
ETS configuration on local port, including Admin
mode (enabled when a valid TLV is received from a
peer), priority groups, assigned dot1p priorities, and
bandwidth allocation.
Port state for current operational ETS configuration:
• Init: Local ETS configuration parameters were
exchanged with peer.
• Recommend: Remote ETS configuration
parameters were received from peer.
• Internally propagated: ETS configuration
parameters were received from configuration
source.
Operational status of ETS configuration on local port:
match or mismatch.
Type of state machine used for DCBx exchanges of
ETS parameters:
• Feature: for legacy DCBx versions
• Asymmetric: for an IEEE version
Status of ETS Configuration TLV advertisements:
enabled or disabled.
Number of ETS Configuration TLVs received.
Number of ETS Configuration TLVs transmitted.
Number of ETS Error Configuration TLVs received.
Data Center Bridging (DCB) 329