Table of Contents
Advertisement
flow-based enable — Specify flow-based enable for mirroring on a flow-by-flow basis and also for VLAN
as source.
destination interface — Enter one of the following keywords and slot/port information.
NOTE:
•
You cannot configure cascade ports as a destination port.
•
For a 10–Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
•
For a 40–Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
•
For a port channel interface, enter the keyword port-channel then the port-channel id.
To display information on currently configured port-monitoring sessions, use the show monitor session
command from EXEC Privilege mode.
The following example monitors and displays information about port extender interface 255/0/0.
Dell(conf)#monitor session 1
source peGigE 255/0/0 destination TenGigabitEthernet 0/23 direction both
Dell(conf-mon-sess-0)#
Dell(conf-mon-sess-0)#do show monitor session 1
SessID Source Destination Dir
------------- ----------- ----------------------------------
1
PeGi
255/0/0
NOTE:
Source as VLAN is achieved via Flow based mirroring.
Mode Source IP Dest IP DSCP TTL Mirrors-Drop?
Te 0/23 both Port
---------------
N/A
N/A
N/A
Port Monitoring
No
861
Advertisement
Table of Contents
Troubleshooting
