Dell C9000 Series Networking Configuration Manual page 328

1 3
2
3
4
5
6
7
Remote Parameters :
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mpbs) Burst(KB)
----------------------------------------------------------
0 0,1,2,4,5,6,7 50 400 100 4000 400 ETS
1 3
2
3
4
5
6
7
Oper status is init
Conf TLV Tx Status is disabled
Traffic Class TLV Tx Status is disabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Traffic Class TLV Pkts, 0 Output Traffic Class TLV Pkts, 0 Error
Traffic Class TLV
Pkts
The following table describes the show interface ets detail command fields.
Table 21. show interface ets detail Command Description
Field
Interface
Maximum Supported TC
Number of Traffic Classes
Admin mode
Admin Parameters
Remote Parameters
50 - - - - ETS
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
50 - - - - ETS
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
Description
Interface type with stack-unit, linecard, and port
number. The port type can be ten gigabit or forty
gigabit.
Maximum number of priority groups supported.
Number of 802.1p priorities currently configured.
ETS mode: on or off.
ETS configuration on local port, including priority
groups, assigned dot1p priorities, and bandwidth
allocation.
ETS configuration on remote peer port, including
Admin mode (enabled if a valid TLV was received or
disabled), priority groups, assigned dot1p priorities,
and bandwidth allocation. If the ETS Admin mode is
enabled on the remote port for DCBx exchange, the
Data Center Bridging (DCB) 328