Enabling Vlt And Creating A Vlt Domain - Dell C9000 Series Networking Configuration Manual

Hide thumbs Also See for C9000 Series:
Table of Contents

Advertisement

3
Add one or more port interfaces to the port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
interface: specify one of the following interface types:
1-Gigabit Ethernet: Enter gigabitethernet slot/port.
10-Gigabit Ethernet: Enter tengigabitethernet slot/port.
40-Gigabit Ethernet: Enter fortyGigE slot/port.
4
Ensure that the port channel is active.
INTERFACE PORT-CHANNEL mode
no shutdown
5
Repeat Steps 1 to 4 on the VLT peer switch to configure the VLT interconnect.

Enabling VLT and Creating a VLT Domain

To enable VLT and create a VLT domain:
1
Enable VLT on a switch, then configure a VLT domain and enter VLT-domain configuration mode.
CONFIGURATION mode
vlt domain domain-id
The domain ID range is from 1 to 1000.
Configure the same domain ID on the peer switch to allow for common peering. VLT uses the domain
ID to automatically create a VLT MAC address for the domain. If you do not configure the system
explicitly, the system mac-address of the primary will be the VLT MAC address for the domain.
To disable VLT, use the no vlt domain command.
NOTE:
Do not use MAC addresses such as "reserved" or "multicast."
2
Configure the IP address of the management interface on the remote VLT peer to be used as the
endpoint of the VLT backup link for sending out-of-band hello messages.
VLT DOMAIN CONFIGURATION mode
back-up destination {ipv4–address] | ipv6 ipv6–address [interval seconds]}
You can optionally specify the time interval used to send hello messages. The range is from 1 to 5
seconds.
3
Configure the port channel to be used as the VLT interconnect between VLT peers in the domain.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
4
(Optional) After you configure a VLT domain on each peer switch and connect (cable) the two VLT peers
on each side of the VLT interconnect, the system elects a primary and secondary VLT peer device (see
Primary and Secondary VLT
Peers). To configure the primary and secondary roles before the election
Virtual Link Trunking (VLT)
1182

Advertisement

Table of Contents
loading

Table of Contents