Remove The Server From The Rack - Oracle SPARC S7-2 Service Manual

Use your right thumb to pull the connector A release lever to the right away
b.
from the left slide rail (callout 1), and use your left hand to pull the connector
out of the slide rail (frames 1 and 2).
No.
1
8. Remove the CMA from the rack and place it on a flat surface.
9. Go to the front of the server and push it back into the rack.

Remove the Server From the Rack

The server weighs approximately 18.1 kg (40.0 lbs). Two people are required to
Caution -
dismount and carry the chassis.
Disconnect all the cables and power cords from the server.
1.
2. Remove the CMA.
See "Remove the Cable Management Arm" on page
3. Extend the server to the maintenance position.
Description
Connector A release lever
42.

Remove the Server From the Rack

Preparing for Service 47