Table of Contents
Advertisement
Remove the Server From the Rack
3.
When you have finished the service steps that require the CMA to be out of the
way, swing the CMA closed and latch it to the left rack rail.
Check that the CMA and the cables are functioning properly after completing service.
Related Information
"Extend the Server to the Service Position" on page 49
■
"Remove the Server From the Rack" on page 52
■
"Returning the Server to Operation" on page 153
■
Remove the Server From the Rack
You must remove the server from the rack to remove or install these components:
Motherboard
■
Drive backplane
■
Caution -
server from the rack.
1.
Shut down the host.
2.
Remove power from the server.
See
"Removing Power From the Server" on page
3.
Disconnect all the cables and power cords from the server.
Extend the server to the maintenance position.
4.
See
"Extend the Server to the Service Position" on page
Release the CMA from the rail assembly.
5.
The CMA is still attached to the cabinet, but the server chassis is now disconnected from the
CMA. See
6.
From the front of the server, pull the release tabs forward and pull the server
forward until it is free of the rack rails.
A release tab is located on each rail.
7.
Set the server on a sturdy work surface.
52
SPARC T8-1 Server Service Manual • January 2022
The server chassis is heavy. To avoid personal injury, use two people to remove the
"Release the CMA" on page
45.
49.
51.
Advertisement
Table of Contents
