YASKAWA L1000A Quick Start Manual page 61

No. Display
11 LO/RE Light
LO
RE
12 ALM LED Light
<1> The STOP key has highest priority. Pressing the STOP key will always cause the drive to stop the motor, even if an Up/Down command is
active at any external Up/Down command source. To disable the STOP key priority, set parameter o2-02 to 0.
<2> The LO/RE key can only switch between LOCAL and REMOTE when the drive is stopped. By default settings the LO/RE key function is
disabled. To allow using the LO/RE key for switching between LOCAL and REMOTE, set parameter o2-01 to 1.
LCD Display
■
Figure 31
No. Name
1 Operation Mode Menus
2 Mode Display Area
3 Ready
4 Data Display
Speed Reference Source
5
Assignment
<1>
LO/RE
6
Display
<2>
Function Key 1
7
(F1)
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide
Name
Lit while the operator is selected to run the drive (LOCAL mode). Refer to page
for details.
Refer to ALARM (ALM) LED Displays on page
1
DRV
- MODE -
Speed Ref (OPR)
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
FWD
9 8
Figure 31 LCD Display
Table 21 Display and Contents
Display
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
Rdy Indicates the drive is ready to run.
– Displays specific data and operation data.
OPR Displayed when the speed reference source is assigned to the LCD Operator.
Displayed when the speed reference source is assigned to MEMOBUS/Modbus
COM
Communication.
OP Displayed when the speed reference is assigned to an option card.
RSEQ Displayed when the Up/Down command is supplied from a remote source.
LSEQ Displayed when the Up/Down command is supplied from the operator keypad.
RREF Displayed when the speed reference is supplied from a remote source.
LREF Displayed when the speed reference is supplied from the operator keypad.
HELP
Pressing
F1
←
Pressing
F1
HOME
Pressing
F1
ESC
Pressing
F1
4 Start-Up Programming & Operation
Function
2 3
Rdy
4
5
RSEQ
6
LREF
FWD/REV
7
Content
displays the Help menu.
scrolls the cursor to the left.
returns to the top menu (Speed Reference).
returns to the previous display.
61.
YEA_common
61
4
59