YASKAWA L1000A Quick Start Manual page 211

No. Name
U1-18 oPE Fault Parameter
MEMOBUS/Modbus
U1-19
Error Code
Software Number
U1-25
(Flash)
U1-26 Software No. (ROM)
<9> Values shown here are for 200 V class drives. Double the value when using a 400 V class drive. Multiply value by 2.875 for 600 V class drives.
<10> The display resolution depends on the rated output power of the drive. Models CIMR-LU20008 to 20033, 40005 to 40018, and
50003 to 50013 display values in 0.01 A units, while models CIMR-LU20047 to 20415, 40024 to 40605, and 50017 to 50200
display values in 0.1 A units.
<12> The display resolution depends on the rated output power of the drive. Models CIMR-LU20008 to 20033, 40005 to 40018, and
50003 to 50013 display values in 0.01 kW units, while models CIMR-LU20047 to 20415, 40024 to 40605, and 50017 to
50200 display values in 0.1 kW units.
<29> Setting units are determined by the digital operator display unit selection (o1-03). When o1-03 = 0, the value is set in Hertz. When o1-03 = 4 or
5, the value is displayed in m/s. When o1-03 = 6, the value is displayed in ft/min.
<40> When checking the values of U1-03, U2-05 and U4-13 with the digital operator they are displayed in units of amperes, but when they are
checked using MEMOBUS communications, the monitor value in MEMOBUS communications is: displayed numeric value / 8192 × drive's
rated current (A), from the condition "8192 (maximum value) = drive's rated current (A)".
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide
Displays the parameter number that caused the oPE02 or oPE08 (Operation error).
Displays the contents of a MEMOBUS/Modbus error.
U1 - 19= 00000000
YEAcom
mon
FLASH ID
ROM ID
Description
1
CRC Error
1
Data Length Error
0
Not Used
1
Parity Error
1
Overrun Error
1
Framing Error
1
Timed Out
0
Not Used
B Parameter Table
Analog Output
Unit
Level
No signal output
–
available
No signal output
–
available
No signal output
–
available
No signal output
–
available
B
209