YASKAWA L1000A Quick Start Manual page 172

B Parameter Table
C2: Jerk Settings
■
No. Name
C2-01 Jerk at Accel Start
C2-02 Jerk at Accel End
C2-03 Jerk at Decel Start
C2-04 Jerk at Decel End
C2-05 Jerk below Leveling Speed Sets the jerk used when the speed reference is lower than the leveling speed setting.
<6> Setting ranges and defaults vary by the setting units determined by parameter o1-03.
Refer to Defaults and Setting Ranges by Display Unit Selection (o1-03) on page
C3: Slip Compensation
■
No. Name
C3-01
Slip Compensation Gain
C3-02
Slip Compensation
Primary Delay Time
C3-03 Slip Compensation Limit
Slip Compensation
C3-04 Selection during
Regeneration
Output Voltage Limit
C3-05
Operation Selection
<5> Default setting is determined by the control mode (A1-02).
170
Five different jerk values can be set. They are automatically applied as shown in the
figure below.
Up/Down command
Output speed
Sets the gain for the motor slip compensation function.
Adjusts the slip compensation function delay time.
Sets an upper limit for the slip compensation function as a percentage of motor rated
slip for motor 1 (E2-02).
0: Disabled.
1: Enabled above 6 Hz.
2: Enabled whenever slip compensation is possible.
0: Disabled.
1: Enabled. Automatically decreases motor flux when output voltage saturation is
reached.
Note: Available control modes for parameter C3-05 vary by drive model: Models
CIMR-LU20008 to 20415, 40005 to 40605, and 50003 to 50200:
Available when A1-02 = 2, 3
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide
Description
ON OFF
C2-02 C2-03
C2-01 C2-04
C2-05
C2-05
Time
215.
Description
Setting
Default: 0.50 s
<6>
Min: 0.00 s
Max: 10.00 s
<6>
Default: 0.50 s
<6>
Min: 0.00 s
Max: 10.00 s
<6>
Default: 0.50 s
<6>
Min: 0.00 s
Max: 10.00 s
<6>
Default: 0.50 s
<6>
Min: 0.00 s
Max: 10.00 s
<6>
Default: 0.50 s
<6>
Min: 0.00 s
Max: 10.00 s
<6>
Setting
Default: 1.0
Min: 0.0
Max: 2.5
Default: 2000 ms
Min: 0 ms
Max: 10000 ms
Default: 200%
Min: 0%
Max: 250%
Default: 0
Min: 0
Max: 2
Default:
<5>
Min: 0
Max: 1