YASKAWA L1000A Quick Start Manual page 176

B Parameter Table
No. Name
d1-25
Rescue Operation Speed
d1-26
Leveling Speed
d1-27 Motor 2 Speed Reference
Leveling Speed Detection
d1-28
Level
Inspection Speed Detection
d1-29
Level
<6> Setting ranges and defaults vary by the setting units determined by parameter o1-03.
Refer to Defaults and Setting Ranges by Display Unit Selection (o1-03) on page
■ d6: Field Forcing
No. Name
d6-03 Field Forcing Selection
d6-06 Field Forcing Limit
174
Sets the speed reference during inspection operation.
Sets leveling speed reference when d1-18 = 1 or 2.
Sets the speed reference for motor 2.
Note:
1. If set to 0.00, the drive will control motor 1 instead.
2. When using motor 2, be sure that the accel/decel times are set in parameters C1-12
and C1-13.
Used when d1-18 = 0 or 3. If the speed reference selected is lower than d1-28, then
the drive uses the leveling speed as the speed reference.
Used when d1-18 = 0 or 3. If the speed reference selected is higher than d1-28 but
lower or equal to d1-29, then the drive uses inspection speed as the speed reference.
0: Disabled
1: Enabled
Sets the upper limit of the excitation current command during magnetic field forcing.
A setting of 100% is equal to motor no-load current. Disabled only during DC
Injection Braking.
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide
Description
215.
Description
Setting
Default:
10.00%
<6>
Min: 0.00%
Max: 100.00%
<6>
Default: 8.00%
<6>
Min: 0.00%
Max: 100.00%
<6>
Default: 0.00 Hz
Min: 0.00 Hz
Max: 200.00 Hz
Default: 0.0%
Min: 0.0%
Max: 100.0%
Default: 0.0%
Min: 0.0%
Max: 100.0%
Setting
Default: 0
Min: 0
Max: 1
Default: 400%
Min: 100%
Max: 400%