Dexcom g4 platinum Quick Start Manual page 184

ANIMAS® VIBE™ SYSTEM
C H AP TE R 8 - C OM PL E TI N G A C GM SE SSIO N
Stop CGM
Stop CGM
sensor
session
STOP
CANCEL
CGM Alert
CGM Session
Stopped
by User
Early Sensor Expiration
In some cases, the CGM session may end before you have completed a full 7-day period. See
Chapter 10 in Section II for more information on the Sensor Failure Warnings that may be displayed
on your pump.
m
WARNING:
• DO NOT use a broken Sensor or attempt to remove the broken Sensor if no portion of it is
visible above the skin. Sensors can fracture on rare occasions. You may not be able to obtain
glucose readings from a broken Sensor or the readings may be inaccurate. Consult your HCP
about removing it, especially if you have symptoms of infection or inflammation (redness,
swelling or pain) at the insertion site. Report the broken Sensor to Customer Service.
• For patients undergoing an MRI with a retained wire broken off from a Sensor, in-vitro MRI
testing did not detect any safety hazards. There was no significant migration or heating of the
wire and imaging artifacts were limited to the area around the wire.
• The pump and any type of metallic infusion set must be removed prior to an MRI, and left
outside the room during the procedure.
P130007
41028900 RevB_OB_VIBE_US_EN_MG_R4.indd 156
3.
With "STOP" highlighted on the Stop CGM screen, press
You will be notified on your pump display that you have stopped the CGM
session. After a few seconds, you will return to the CGM Menu screen.
156
Dec 2014
.
A266 of A312
11/14/14 2:53 PM