Dexcom g4 platinum Quick Start Manual page 148

ANIMAS® VIBE™ SYSTEM
C H AP TE R 2 - C GM S ET TI N G S
Transmitter
S/N #
6 0 0 0 0
CGM Setup
Transmitter
S/N #
6 0 0 0 0
CGM Setup
Transmitter
S/N # 6 8 7 A
CGM Setup
Transmitter
S/N # 6 8 7 A B
CGM Setup
NOTE:
• If this is the first time you are entering a Transmitter ID, all zeros (00000) will appear in the "S/N#"
field.
• You cannot enter a Transmitter ID when a CGM session is currently active.
• Entering a valid Transmitter ID but not inserting a Transmitter/Sensor may trigger certain CGM
warnings, alarms and alerts to display/sound on your pump.
P130007
41028900 RevB_OB_VIBE_US_EN_MG_R4.indd 120
5.
Scroll to the "S/N#" field. The last digit will be highlighted. Scroll to the
first digit and then press
NOTE:
• The Transmitter ID appears on the underside of the Transmitter.
• The Transmitter ID should begin with 6 or 7.
6.
Use the / buttons to enter the first number/letter of the Transmitter
ID. Press to move to the next digit and press
digit is flashing.
7.
Repeat these steps until you have correctly entered all 5 numbers/letters
from your Transmitter ID. Press
B
8.
"CGM Setup" will be highlighted. If you need to edit the Transmitter ID you
just entered, scroll to the "S/N#" field and re-enter the correct Transmitter ID.
With "CGM Setup" highlighted, press
so that the first digit is flashing.
again so that the second
when the last digit is highlighted.
to return to the CGM Setup screen.
120
Dec 2014 A230 of A312
11/14/14 2:53 PM