Review Lamp Pre-Wiring; Check Lamp Cradle (Anode End) Location; Install Lamp; Connecting To Power - Christie CP2000 Setup Manual

REVIEW LAMP PRE-WIRING

Review all lamp pre-wiring, as described on the previous pages, ensuring all leads and harnesses are
connected correctly and that the universal cathode connector nut is secured to the rear lamp post.

CHECK LAMP CRADLE (ANODE END) LOCATION

• For 4.5 or 6.0 kW lamps, the lamp cradle must be as far for-
ward as possible (factory default).
• For 2.0 or 3.0 kW lamps, move the cradle to the rear posi-
tion (i.e., approximately 1" closer to the reflector) (Figure 2-
19 Lamp Cradle Position).

INSTALL LAMP

Observe all warnings, and wear protective clothing and
shielding.

2.1.6 CONNECTING TO POWER

NOTE: For CP2000-S Models - Refer to the Addendum for
Installation and Use provided. Before connecting to AC,
configure the lamp ballast to match the AC available at the
site.
Connecting the CP projector to your AC supply can vary
according to the country in which the CP is installed. The five
scenarios are explained below. For any installation, always
follow the electrical code for your country.
Certified electrician required. Follow the Terminal Block 1 (TB1) Connections diagram
located on the inside of the pedestal.
Installation of the pedestal's conduit panel is mandatory to avoid risk of electric shock
causing bodily harm or even death.
1. From the AC power source, route 3-phase wires, single-phase and ground wires into one of the
knock-out holes located on the pedestal's conduit panel. Use appropriately sized strain relief
connectors with the conduit panel, which will ensure adequate environmental sealing, prevent
cables from wear and being accidentally torn out. Use of the conduit panel is mandatory to
prevent electric shock.
2. Connect the incoming AC ground lead directly to the frame ground lug on the floor of the pedestal
(Figure 2-20 Connect Incoming Ground Wire). Secure using the washers and nut provided. Ensure
no other wires are present at this lug.
Connect ground first to reduce shock hazard from high leakage.
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)
F
IGURE
WARNING
WARNING
WARNING
Section 2: Installation and Setup
2-19 L C
AMP RADLE
P
OSITION
2-13