Replace The Lamp; Remove The Existing Lamp - Christie CP2215 Service Manual

Parts and Module Replacement

Replace the Lamp

• Lamp replacement must be performed by a qualified service technician. Failure to comply
• EXPLOSION HAZARD. Wear authorized protective clothing whenever the lamp door is
• Ensure those within the vicinity of the projector are also wearing protective safety
• Never attempt to remove the lamp when it is hot. The lamp is under pressure when hot
Improper installation of the lamp can damage the projector. Failure to comply could result in
death or serious injury

Remove the Existing Lamp

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Put on your protective clothing and face shield.
4. Insert the key in the lock on the lamp door, turn the key, and then open the lamp door. Do not
place heavy objects on the open lamp door.
5. Loosen the two thumbscrews and open the lamp access door.
6. Remove the screw securing the anode wire. It is recommended that you use a 5 mm magnetized
ball driver.
28
results in death or serious injury.
open and when handling the lamp. Never twist or bend the quartz lamp body. Use the
correct wattage lamp supplied by Christie. Failure to comply results in death or serious
injury.
clothing including a full face shield, Kevlar gloves, and a ballistic nylon jacket. Failure to
comply results in death or serious injury.
and may explode, causing personal injury, death, or property damage. Allow the lamp to
cool completely before replacing it. Failure to comply results in death or serious injury.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)