Precautions For Installing Mobile Communication Equipment; Air Bag Warning; Discharge Headlight Warning - Suzuki GRAND VITARA 2005 Manual

00-11 Precautions:
• When taking measurements at electrical connectors
using a tester probe, be sure to insert the probe (2)
from the wire harness side (backside) of the
connector (1).
• When connecting meter probe (2) from terminal side
of coupler (1) because it can't be connected from
harness side, use extra care not to bend male
terminal of coupler of force its female terminal open
for connection.
In case of such coupler as shown connect probe as
shown to avoid opening female terminal.
Never connect probe where male terminal is
supposed to fit.
• When checking connection of terminals, check its
male half for bend and female half for excessive
opening and both for locking (looseness), corrosion,
dust, etc.
• Before measuring voltage at each terminal, check to
make sure that battery voltage is 11 V or higher. Such
terminal voltage check at low battery voltage will lead
to erroneous diagnosis.
Precautions for Installing Mobile
Communication Equipment
When installing mobile communication equipment such
as CB (Citizens-Band)-radio or cellular-telephone, be
sure to observe the following precautions.
Failure to follow cautions may adversely affect electronic
control system.
• Keep the antenna as far away as possible from the
vehicle's electronic control unit.
• Keep the antenna feeder more than 20 cm (7.9 in.)
away from electronic control unit and its wire
harnesses.
• Do not run the antenna feeder parallel with other wire
I2RH01010046-01
harnesses.
• Confirm that the antenna and feeder are correctly
adjusted.

Air Bag Warning

WARNING
!
For vehicles equipped with Supplemental
Restraint (Air Bag) System:
• Service on and around the air bag system
components or wiring must be performed
only by an authorized SUZUKI dealer. Refer
to "Air Bag System Components, Wiring
and Connectors Location in Section 8B" in
order to confirm whether you are
performing service on or near the air bag
system components or wiring. Please
observe all "WARNING"s and "Precautions
on Service and Diagnosis of Air Bag
I2RH01010047-01
System in Section 8B" before performing
service on or around the air bag system
components or wiring. Failure to follow
"WARNING"s could result in unintentional
activation of the system or could render
the system inoperative. Either of these two
conditions may result in severe injury.
• Technical service work must be started at
least 90 seconds after the ignition switch is
turned to the "LOCK" position and the
negative cable is disconnected from the
battery. Otherwise, the system may be
activated by reserve energy in the Sensing
and Diagnostic Module (SDM).

Discharge Headlight Warning

WARNING
!
When performing service on and around the
discharge headlight, observe "Precautions
I2RH01010048-01
for Discharge Headlight Service (If Equipped)
in Section 9B". Neglecting the warnings may
result in personal injury.
S6JB0A0000008
S6JB0A0000009
S6JB0A0000010