Siemens SINAMICS S120 Function Manual page 52

Extended Setpoint Channel
Extended setpoint channel
Function diagram overview (refer to the List Manual)
S 1550
S 2501
S 3020
Parameter overview (see List Manual)
S p1030[D]
S p1035[C]
S p1036[C]
S p1037[D]
S p1038[D]
S p1039[C]
S p1040[D]
S p1041[C]
S p1042[C]
S p1043[C]
S p1044[C]
S r1045
S p1047[D]
S p1048[D]
S r1050
S p1082[D]
Parameterization with STARTER
In the STARTER commissioning tool, the "Motorized potentiometer" parameter
screen in the project navigator under the relevant drive is activated by double-
clicking Setpoint channel –> Motorized potentiometer.
2-52
Setpoint channel
Control word sequence control
Motorized potentiometer
Motorized potentiometer, configuration
BI: Motorized potentiometer, setpoint, raise
BI: Motorized potentiometer, lower setpoint
Motorized potentiometer, maximum speed
Motorized potentiometer, minimum speed
BI: Motorized potentiometer, inversion
Motorized potentiometer, starting value
BI: Motorized potentiometer, manual/automatic
CI: Motorized potentiometer, automatic setpoint
BI: Motorized potentiometer, accept setpoint
CI: Motorized potentiometer, setting value
CO: Motorized potentiometer, speed setpoint in front of the
ramp-function generator
Motorized potentiometer, ramp-up time
Motorized potentiometer, ramp-down time
CO: Motorized potentiometer, setpoint after the ramp-function
generator
Maximum speed
© Siemens AG 2006 All Rights Reserved
SINAMICS S120 Function Manual, 03/2006 Edition