Siemens SINAMICS S120 Function Manual page 101

Type plate data
Rating plate data input requires the following parameters:
Table 3-9 Type plate data
Induction motor
S
p0304 rated voltage
S
p0305 rated current
S
p0307 rated power
S
p0308 rated power factor (cos ϕ)
S
p0310 rated frequency
S
p0311 rated speed
S
p0322 maximum motor speed
S
p0353 motor series inductance
S
p0400ff encoder data
Since the type plate data contains the initialization values for identification, you
must ensure that it is entered correctly and consistently to enable the above data
to be determined.
Parameters to control the MotID
The following parameters influence the MotID:
Table 3-10 Parameters for control
Static measurement (motor data identification)
S
p0640 current limit
S
p1215 motor holding brake configuration
S
p1909 motor data identification control word
S
p1910 motor data identification, stationary
S
p1959.14/.15 clockwise/counter-clockwise
direction or rotation permitted
Note:
If a brake is being used and is operational (p1215 = 1, 3), then the stationary measurement with closed
brake is carried-out. If possible (e.g. no hanging/suspended axis), we recommend that the brake is
opened before the MotID (p1215 = 2). This also means that the encoder size can be adjusted and the
angular commutation calibrated.
© Siemens AG 2006 All Rights Reserved
SINAMICS S120 Function Manual, 03/2006 Edition
Permanent-magnet synchronous motor
S
p0304 rated voltage
S
p0305 rated current
S
p0307 rated power (alternative p0316)
S
p0311 rated speed
S
p0314 motor pole pair number
or p0315 motor pole pair width
S
p0322 maximum motor speed
S
p0323 maximum motor current
S
p0353 motor series inductance
S
p0400ff encoder data
Rotating measurement
S
p
0640 current limit
S
p1082 maximum speed
S
p1958 motor data identification
ramp-up/ramp-down time
S
p1959 rotating measurement configuration
S
p1960 rotating measurement selection
Operating Modes
Servo control
3-101