Setting The Port Addressed In Maintenance Mode - Kyocera TASKalfa 2551ci Service Manual

Hide thumbs Also See for TASKalfa 2551ci:

Table of Contents

Setting the port addressed in maintenance mode

Configures the port that is addressed in maintenance mode.

To configure the port that is addressed in maintenance mode when the optional dual FAX is

It is not required to assign the same settings to both ports. It should be used to assign different

settings to each port.

This maintenance item is shown only when the optional dual FAX has been installed.

1. Press the start key.

2. Press [PORT SELECT]. The current setting is displayed in reverse.

3. Select the item to be set.

Initial setting: ALL

4. Press the start key. The setting is set.

Press the stop key. The screen for selecting a maintenance item No. is displayed.

The setting must be made after re-entering maintenance mode because it will be cleared when

maintenance mode is canceled and power is switched off.

Port 1 (Fax control PWB)

Port 2 (Optional dual FAX)

Show Quick Links

Table of Contents

Do you have a question about the TASKalfa 2551ci and is the answer not in the manual?