Chapter 36 Gratuitous Arp Command List - D-Link DGS-3000 Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 36
config gratuitous_arp send ipif_status_up [enable | disable]
config gratuitous_arp send dup_ip_detected [enable | disable]
config gratuitous_arp learning [enable | disable]
config gratuitous_arp send periodically ipif <ipif_name 12> interval <value 0-65535>
enable gratuitous_arp {ipif <ipif_name 12>} {trap | log}(1)
disable gratuitous_arp {ipif <ipif_name 12>} {trap | log}(1)
show gratuitous_arp {ipif <ipif_name 12>}
36-1 config gratuitous_arp send ipif_status_up
Description
This command is used to enable or disable the sending of gratuitous ARP packets when the IP
interface's status is up. This is used to automatically announce the interface's IP address to other
nodes. Only one gratuitous ARP packet will be broadcasted.
Format
config gratuitous_arp send ipif_status_up [enable | disable]
Parameters
enable - Enables the sending of gratuitous ARP packets when the IP interface's status is up. This
is the default value.
disable - Disables the sending of gratuitous ARP packets when the IP interface's status is up.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable send gratuitous ARP request in normal situation:
DGS-3000-26TC:admin#config gratuitous_arp send ipif_status_up enable
Command: config gratuitous_arp send ipif_status_up enable
Success.
DGS-3000-26TC:admin#
Gratuitous ARP Command
List
377