D-Link DGS-3000 Reference Manual page 498

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3000-26TC:admin#show lldp
Command: show lldp
LLDP System Information
Chassis ID Subtype
Chassis ID
System Name
System Description
System Capabilities
LLDP Configurations
LLDP Status
LLDP Forward Status
Message TX Interval
Message TX Hold Multiplier: 4
ReInit Delay
TX Delay
Notification Interval
DGS-3000-26TC:admin#
46-8 show lldp mgt_addr
Description
This command is used to display the LLDP management address information.
Format
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Parameters
ipv4 - (Optional) Specify the IPv4 address used for the display.
<ipaddr> - Enter the IPv4 address used for this configuration here.
ipv6 - (Optional) Specify the IPv6 address used for the display.
<ipv6addr> - Enter the IPv6 address used for this configuration here.
Restrictions
None.
Example
To display management address information:
: MAC Address
: 00-01-02-03-04-00
:
: Gigabit Ethernet Switch
: Repeater, Bridge
: Enabled
: Enabled
: 30
: 2
: 2
: 5
494