D-Link DGS-3000 Reference Manual page 320

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
25-4 show ddm ports
Description
This command is used to show the current operating DDM parameters and configuration values of
the optic module of the specified ports. There are two types of thresholds: the administrative
configuration and the operation configuration threshold.
For the optic port, when a particular threshold was configured by user, it will be shown in this
command with a tag indicating that it is a threshold that user configured, else it would be the
threshold read from the optic module that is being inserted.
Format
show ddm ports {<portlist>} [status | configuration]
Parameters
<portlist> - (Optional) Enter the range of ports to be displayed here.
status - Specify that the operating parameter will be displayed.
configuration - Specify that the configuration values will be displayed.
Restrictions
None.
Example
To display ports 25-26's operating parameters:
DGS-3000-26TC:admin#show ddm ports 25-26 status
Command: show ddm ports 25-26 status
Port Temperature
(in Celsius)
------- ------------- ---------- -------------- ---------- ------------
25 -
26 -
CTRL+C ESC q Quit SPACE n
25-5 config ddm power_unit
Description
This command is used to configure the unit of DDM TX and RX power.
Format
config ddm power_unit [mw | dbm]
Parameters
mw - Specify the DDM TX and RX power unit as mW.
Voltage Bias Current
(V) (mA)
- -
- -
Next Page p Previous Page
316
TX Power RX Power
(mW) (mW)
- -
- -
r Refresh