D-Link DGS-3000 Reference Manual page 344

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3000-26TC:admin# config erps raps_vlan 4094 sub_ring raps_vlan 4093
tc_propagation state enable
Command: config erps raps_vlan 4094 sub_ring raps_vlan 4093 tc_propagation
state enable
Success.
DGS-3000-26TC:admin#
30-6 config erps log
Description
This command is used to configure the log state of the ERPS events.
Format
config erps log [enable | disable]
Parameters
enable - Specify to enable an ERPS event in the log state.
disable - Specify to disable an ERPS event in the log state.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the ERPS log state:
DGS-3000-26TC:admin# config erps log enable
Command: config erps log enable
Success.
DGS-3000-26TC:admin#
30-7 show erps
Description
This command is used to display ERPS configuration and operation information.
The port state of the ring port may be as "Forwarding", "Blocking", "Signal Fail". "Forwarding"
indicates that traffic is able to be forwarded. "Blocking" indicates that traffic is blocked by ERPS
and a signal failure is not detected on the port. "Signal Fail" indicates that a signal failure is
detected on the port and traffic is blocked by ERPS.
This command displays both admin value and operational value of ring port. The admin value is
the latest user configuration. The operational value is actual running configuration. Sometimes,
modifying a ring needs more than one command. Before user configure complete, the current
340