D-Link DGS-3000 Reference Manual page 814

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
If no parameter is specified, all hosts will be displayed.
Restrictions
None.
Example
To show the syslog host information:
DGS-3000-26TC:admin#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host 1
IP Address
Severity
Facility
UDP Port
Status
Total Entries : 1
DGS-3000-26TC:admin#
83-11 config log_save_timing
Description
This command is used to set the method for saving the log.
Format
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
Parameters
time_interval - Specify the time interval used for saving the log. If there is no new log event
during this time interval, the Switch will not save any log entries.
<min 1-65535> - Enter the time interval value here. This value must be between 1 and 65535
minutes.
on_demand - Specify that the log will only be saved when an on-demand event occurs. For
example, issuing the command save all or save log. This is the default option.
log_trigger - Specify that the log will be saved when a new log event is triggered.
Restrictions
Only Administrators and Operators can issue this command.
: 10.90.90.1
: Debug(7)
: Local0
: 514
: Disabled
810