Create Snmp - D-Link DGS-3000 Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3000-26TC:admin#show snmp view
Command: show snmp view
Vacm View Table Settings
View Name
---------------------
view123
restricted
restricted
restricted
restricted
restricted
CommunityView
CommunityView
CommunityView
Total Entries: 9
DGS-3000-26TC:admin#
78-17

create snmp

Description
This command is used to create a recipient of an SNMP trap operation.
Format
create snmp [host <ipaddr> | v6host <ipv6addr>] [v1 | v2c | v3 [noauth_nopriv | auth_nopriv
| auth_priv]] <auth_string 32>
Parameters
host - Specify the recipient for which the traps are targeted.
<ipaddr> - Enter the IP address of the recipient for which the traps are targeted.
v6host - Specify the IPv6 host address to which the trap packet will be sent.
<ipv6addr> - Enter the IPv6 address of the recipient for which the traps are targeted.
v1 - Specify that SNMPv1 will be used. The is the least secure of the possible security models.
v2c - Specify that SNMPv2c will be used. This is the second least secure of the possible security
models.
v3 - Specify that SNMPv3 will be used. This is the most secure of the possible security models.
noauth_nopriv - Neither supports packet authentication nor encryption.
auth_nopriv - Supports packet authentication.
auth_priv - Supports packet authentication and encryption.
<auth_string 32> - Enter the authentication string. If the v1 or v2 is specified, the auth_string
presents the community string, and it must be one of the entries in the community table. If the
v3 is specified, the auth_string presents the user name, and it must be one of the entries in
the user table.
Restrictions
Only Administrators can issue this command.
Subtree
------------------------
1.3.6
1.3.6.1.2.1.1
1.3.6.1.2.1.11
1.3.6.1.6.3.10.2.1
1.3.6.1.6.3.11.2.1
1.3.6.1.6.3.15.1.1
1
1.3.6.1.6.3
1.3.6.1.6.3.1
761
View Type
----------
Included
Included
Included
Included
Included
Included
Included
Excluded
Included