D-Link DGS-3000 Reference Manual page 399

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3000-26TC:admin#enable igmp_snooping
Command: enable igmp_snooping
Success.
DGS-3000-26TC:admin#
38-8 disable igmp_snooping
Description
This command is used to disable IGMP snooping on the Switch. Disabling IGMP snooping allows
all IGMP and IP multicast traffic to flood within a given IP interface.
Format
disable igmp_snooping
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable IGMP snooping on the Switch:
DGS-3000-26TC:admin#disable igmp_snooping
Command: disable igmp_snooping
Success.
DGS-3000-26TC:admin#
38-9 create igmp_snooping static_group
Description
This command is used to create an IGMP snooping static group. Member ports can be added to
the static group. The static member and the dynamic member port form the member ports of a
group.
The static group will only take effect when IGMP snooping is enabled on the VLAN. For those
static member ports, the device needs to emulate the IGMP protocol operation to the querier, and
forward the traffic destined to the multicast group to the member ports.
For a layer 3 device, the device is also responsible to route the packet destined for this specific
group to static member ports.
395