D-Link DGS-3000 Reference Manual page 167

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Parameters
<string 22> - Enter the maintenance association name. This name can be up to 22 characters
long.
ma_index - Specify the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value must
be between 1 and 4294967295.
md - Specify the maintenance domain name.
<string 22> - Enter the maintenance domain name here. This name can be up to 22
characters long.
md_index - Specify the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value here. This value must
be between 1 and 4294967295.
vlanid - Specify the VLAN Identifier. Different MAs must be associated with different VLANs.
<vlanid 1-4094> - Enter the VLAN ID used here. This value must be between 1 and 4094.
mip - Specify to configure MIPs.
none - Specify not to create MIPs.
auto - MIPs can always be created on any ports in this MA, if that port is not configured with
an MEP of that MA.
explicit - MIP can be created on any ports in this MA, only if the next existing lower level has
an MEP configured on that port, and that port is not configured with an MEP of this MA.
defer - Inherit the setting configured for the maintenance domain that this MA is associated
with. This is the default value.
sender_id - This is the control transmission of the sender ID TLV.
none - Specify not to transmit the sender ID TLV. This is the default value.
chassis - Transmits the sender ID TLV with the chassis ID information.
manage - Transmits the sender ID TLV with the manage address information.
chassis_manage - Transmits the sender ID TLV with the chassis ID information and the
manage address information.
defer - Inherits the setting configured for the maintenance domain that this MA is associated
with. This is the default value.
ccm_interval - Specify the CCM interval.
10ms - Specify that the CCM interval will be set to 10 milliseconds. Not recommended.
100ms - Specify that the CCM interval will be set to 100 milliseconds. Not recommended.
1sec - Specify that the CCM interval will be set to 1 second.
10sec - Specify that the CCM interval will be set to 10 seconds. This is the default value.
1min - Specify that the CCM interval will be set to 1 minute.
10min - Specify that the CCM interval will be set to 10 minutes.
mepid_list - Specify the MEPIDs contained in the maintenance association. The range of the
MEPID is 1-8191.
add - Specify to add MEPID(s).
delete - Specify to delete MEPID(s). By default, there is no MEPID in a newly created
maintenance association.
<mepid_list> - Enter the MEP ID list here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a CFM MA:
163