D-Link DGS-3000 Reference Manual page 135

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Format
show ipif {<ipif_name 12>}
Parameters
<ipif_name 12> - (Optional) Enter the IP interface name used here. This name can be up to 12
characters long.
Restrictions
None.
Example
To display an IP interface:
DGS-3000-26TC:admin#show ipif
Command: show ipif
IP Interface
VLAN Name
Interface Admin State
DHCPv6 Client State
Link Status
IPv4 Address
IPv4 State
IPv6 State
DHCP Option12 State
DHCP Option12 Host Name
Total Entries: 1
DGS-3000-26TC:admin#
10-19 enable ipif_ipv6_link_local_auto
Description
This command is used to enable the auto configuration of link local address when there are no
IPv6 addresses explicitly configured. When an IPv6 address is explicitly configured, the link local
address will be automatically configured, and the IPv6 processing will be started. When there is no
IPv6 address explicitly configured, by default, link local address is not configured and the IPv6
processing will be disabled. By enable this automatic configuration, the link local address will be
automatically configured and IPv6 processing will be started.
Format
enable ipif_ipv6_link_local_auto [<ipif_name 12> | all]
: System
: default
: Enabled
: Disabled
: LinkUp
: 10.90.90.90/8 (Manual)
: Enabled
: Enabled
: Disabled
:
131