Chapter 2 Basic Command List - D-Link DGS-3000 Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Chapter 2
show session
show serial_port
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] | auto_logout [never | 2_minutes |
5_minutes | 10_minutes | 15_minutes]}
enable clipaging
disable clipaging
login
logout
?
clear
show command_history
config command_history <value 1-40>
config greeting_message {default}
show greeting_message
config command_prompt [<string 16> | username | default]
config terminal width [default | <value 80-200>]
show terminal width
config ports [<portlist> | all] {medium_type [fiber | copper]} {speed [auto {capability_advertised
{10_half | 10_full | 100_half | 100_full | 1000_full}} | 10_half | 10_full | 100_half | 100_full |
1000_full {[master | slave]} | 10g_full ] | auto_negotiation [restart_an | remote_fault_advertised
[disable | offline | link_fault | auto_negotiation_error]] | flow_control [enable | disable] | learning
[enable | disable ] | state [enable | disable] | mdix [auto | normal | cross] | [description <desc 1-
32> | clear_description] | auto_speed_downgrade [enable | disable]}(1)
show ports {<portlist>} {[description | err_disabled | auto_negotiation | details | media_type]}
2-1 show session
Description
This command is used to display a list of current users logged into the Switch.
Format
show session
Parameters
None.
Restrictions
Only administrators and Operators can issue this command.
Example
To display the session entries:
Basic Command List
8