D-Link DGS-3000 Reference Manual page 394

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
DGS-3000-26TC:admin#config igmp_snooping vlan_name default state enable
Command: config igmp_snooping vlan_name default state enable
Success.
DGS-3000-26TC:admin#
38-2 config igmp_snooping rate_limit
Description
This command is used to configure the rate of IGMP control packet that is allowed per port or per
VLAN.
Format
config igmp_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list here.
<value 1-1000> - Enter the rate of the IGMP control packet that the Switch can process on a
specific port/VLAN. The rate is specified in packets per second. The packets that exceed the
limit will be dropped.
no_limit - Specify the rate of the IGMP control packet to be unlimited that the Switch can process
on a specific port/VLAN. The rate is specified in packets per second. The packets that exceed
the limit will be dropped. The default setting is no_limit.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the IGMP snooping per port rate_limit:
DGS-3000-26TC:admin#config igmp_snooping rate_limit ports 1 100
Command: config igmp_snooping rate_limit ports 1 100
Success.
DGS-3000-26TC:admin#
390