D-Link DGS-3000 Reference Manual page 452

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Example
To disable JWAC:
DGS-3000-26TC:admin#disable jwac
Command: disable jwac
Success.
DGS-3000-26TC:admin#
42-3 config jwac
Description
This command is used to configure the quarantine server URL. If the redirection is enabled and the
redirection destination is a quarantine server, when a HTTP request from an unauthenticated host
which is not headed to a quarantine server reaches the Switch, the Switch will handle this HTTP
packet and send back a message to the host to make it access the quarantine server with the
configured URL. When the PC connected to the specified URL, the quarantine server will request
the PC user to input the user name and password to authenticate.
NOTE: If the quarantine server is linked to the JWAC enabled port on the switch, it must be added
to the static FDB correctly before it can work properly.
Format
config jwac [quarantine_server_url [<string 128> | ipv6 <string 128>] |
clear_quarantine_server_url {ipv6}]
Parameters
quarantine_server_url - Specify the entire URL of the authentication page on the quarantine
server.
<string 128> - Enter the entire URL of the authentication page on the quarantine server. The
quarantine server URL can be up to 128 characters long.
ipv6 - Specify the entire URL of authentication page on Quarantine Server of IPv6.
<string 128> - Enter up to 128 characters for the quarantine server URL.
clear_quarantine_server_url - Specify to clear the current quarantine server URL.
ipv6 - (Optional) Clear the Quarantine Server URL of IPv6.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the quarantine server URL:
448