Config Syslog Host - D-Link DGS-3000 Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
critical - Severity level 2.
error - Severity level 3.
warning - Severity level 4.
notice - Severity level 5.
informational - Severity level 6.
debug - Severity level 7.
<level 0-7> - Enter the severity level value here. This value must be between 0 and 7.
facility - (Optional) Some of the operating system daemons and processes have been assigned
Facility values. Processes and daemons that have not been explicitly assigned a Facility may
use any of the "local use" facilities or they may use the "user-level" Facility. Those Facilities
that have been designated are shown below. This facility setting will be put in the syslog
packet when it is sent to a specific syslog server.
local0 - Specify that the user-defined facility will be set to local 0.
local1 - Specify that the user-defined facility will be set to local 1.
local2 - Specify that the user-defined facility will be set to local 2.
local3 - Specify that the user-defined facility will be set to local 3.
local4 - Specify that the user-defined facility will be set to local 4.
local5 - Specify that the user-defined facility will be set to local 5.
local6 - Specify that the user-defined facility will be set to local 6.
local7 - Specify that the user-defined facility will be set to local 7.
udp_port - (Optional) Specify the UDP port number.
<udp_port_number> - Enter the UDP port number used here.
state - (Optional) The syslog protocol is used for the transmission of event notification messages
across networks to a host. The option enables or disables the host to receive such messages.
enable - Specify that the host to receive such messages will be enabled.
disable - Specify that the host to receive such messages will be disabled.
Restrictions
Only Administrators and Operators can issue this command.
Example
Adds a new syslog host:
DGS-3000-26TC:admin#create syslog host 1 ipaddress 10.90.90.1 severity debug
facility local0
Command: create syslog host 1 ipaddress 10.90.90.1 severity debug facility
local0
Success.
DGS-3000-26TC:admin#
83-8

config syslog host

Description
This command is used to configure the syslog host configurations. The user can choose and report
a specific level of messages to a specific host. When the user chooses a specific level for a
specific host, messages which are at that severity level or higher will be reported to the specified
host.
807