D-Link DGS-3000 Reference Manual page 483

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
45-2 delete link_aggregation group_id
Description
This command is used to delete a previously configured link aggregation group.
Format
delete link_aggregation group_id <value>
Parameters
group_id - Specify the group id. The number of link aggregation groups is project dependency.
The group number identifies each of the groups.
<value> - Enter the group ID value here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete link aggregation group:
DGS-3000-26TC:admin#delete link_aggregation group_id 3
Command: delete link_aggregation group_id 3
Success.
DGS-3000-26TC:admin#
45-3 config link_aggregation group_id
Description
This command is used to configure a previously created link aggregation group.
Format
config link_aggregation group_id <value> {master_port <port> | ports <portlist> | state
[enable | disable]
Parameters
group_id - Specify the group ID. The group number identifies each of the groups.
<value> - Enter the group ID value here. For the DGS-3000-10TC, this value must be
between 1 and 5. For the DGS-3000-24TC, this value must be between 1 and 12. For the
DGS-3000-26TC, this value must be between 1 and 13.
master_port - (Optional) Master port ID. Specify which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link aggregation group will share
the port configuration with the master port.
<port> - Enter the master port number here.
ports - (Optional) Specify a range of ports that will belong to the link aggregation group.
479