Arp Table; Gratuitous Arp; Gratuitous Arp Global Settings - D-Link DGS-3000 Series Reference Manual

ARP Table

Users can display current ARP entries on the Switch.
To view the following window, click Management > ARP > ARP Table as shown below:
The fields that can be configured are described below:
Parameter
Interface Name
IP Address
MAC Address
Click the Find button to locate a specific entry based on the information entered.
Click the Show Static button to display only the static entries in the display table.
Click the Clear All button to remove all the entries listed in the table.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

Gratuitous ARP

Gratuitous ARP Global Settings

The user can enable or disable the gratuitous ARP global settings here.
To view the following window, click Management > Gratuitous ARP > Gratuitous ARP Global Settings as shown
below:
The fields that can be configured are described below:
Parameter
Send On IP Interface
Status Up
Send On Duplicate IP
Detected
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 3-2 ARP Table window
Description
Enter the Interface name used.
Enter the IP Address used.
Enter the MAC Address used.
Figure 3-3 Gratuitous ARP Global Settings Window
Description
The command is used to enable/disable the sending of gratuitous ARP request packets
while the IPIF interface comes up. This is used to automatically announce the
interface's IP address to other nodes. By default, the state is Enabled, and only one
gratuitous ARP packet will be broadcast.
The command is used to enable/disable the sending of gratuitous ARP request packet
while a duplicate IP is detected. By default, the state is Enabled. For this command, the
35