Debug Config State - D-Link DGS-3000 Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Restrictions
Only Administrators can issue this command.
Example
To set the Switch to not need a reboot when a fatal error occurs:
DGS-3000-26TC:admin#debug config error_reboot disable
Command: debug config error_reboot disable
Success.
DGS-3000-26TC:admin#
18-5

debug config state

Description
This command is used to set the state of the debug.
Format
debug config state [enable | disable]
Parameters
enable - Enables the debug state.
disable - Disables the debug state.
Restrictions
Only Administrators can issue this command.
Example
To set the debug state to disabled:
DGS-3000-26TC:admin#debug config state disable
Command: debug config state disable
Success.
DGS-3000-26TC:admin#
18-6 debug show error_reboot state
Description
This command is used to display debug error reboot state.
202