Maintenance Menu - MIMAKI UJV100-160 Operation Manual

3.2 Maintenance Menu

This menu is used for maintenance actions. It also lets the user perform nozzle recovery if nozzle clogging
persists even after cleaning and nozzle washing.
l Menu List
Item
Station
Carriage Out
Move To
Platen Right
End
Move To
Maint. Space
Nozzle Wash
Pump Tube
Cleaning
Custody Wash
Replace Wiper
Nozzle Recovery
Print
Entry
Reset
Check
Test printing
Auto Maint.
Refresh 0.5 to 4.0 h
Cleaning Interval
*1
Setting
- This moves the carriage to allow station and print head maintenance.
-
- Cleans around the station, including the cap, wiper, and NCU.
"Wiper Cleaning"(P. 95)
"Cap Rubber Cleaning"(P. 96)
"NCU Cleaning"(P. 97)
- Cleans around the print head.
"Carriage Underside Cleaning"(P. 98)
"Media Sensor Cleaning"(P. 101)
"Automatic Correction Sensor (DAS) Cleaning"(P. 99)
- Washes the print head nozzle surface with maintenance liquid to
resolve print defects (e.g., nozzle clogging, deflection).
"Print Head Nozzle Washing"(P. 122)
- Washes the suction pump tube (below the cap).
"Ink Discharge Channel Cleaning"(P. 100)
- Perform this step if the machine will not be used for extended
periods. The function washes nozzles and drainage channels to
maintain the machine in optimal condition.
"When this Printer is Left Unused for a Long Time"(P. 103)
- Use this function when replacing the wiper. Replacing the wiper
resets the wiper usage counter.
"Wiper Replacement"(P. 106)
- Allows other nozzles to be used for printing if maintenance actions
like nozzle washing fail to resolve print defects (e.g., nozzle clogging,
deflection).
- Prints a pattern to check nozzle condition and register the nozzle.
"Registering Nozzle Recovery"(P. 80)
- Registers the nozzle without printing a pattern.
- Initializes the details set.
- Checks if nozzle recovery is possible for the registered nozzle.
"Checking whether nozzle recovery is set correctly"(P. 81)
ON/OFF Sets whether to perform nozzle recovery before test printing.
- Sets various maintenance actions to be performed automatically. Set
the interval between individual maintenance actions.
• If the warning message "Replace Wasteinktank" appears, the
automatic maintenance function is disabled.
Replacement"(P. 115)
Sets the refresh interval.
• Ejects a small amount of ink from the print head nozzles. This
will help prevent nozzle clogging.
1 to 12 h Sets head cleaning intervals.
Details
79
Chapter 3 Settings
"Waste Ink Tank
3