Replacing The Dc/Dc Converter; Scsi Cable; Removing The Scsi Cable; Figure 8-4 Disconnecting The Scsi Cable From The I/O Board - Sun Microsystems SPARCstation Voyager Service Manual

Replacing the DC/DC Converter

1. Align the DC/DC converter on the four threaded studs.
See
FIGURE 8-3
2. Install and tighten the four threaded standoffs on the studs.
See
FIGURE 8-3
3. Connect the DC/DC converter connector to the CPU board connector.
See
FIGURE 8-1
4. Close the system and power it on.

SCSI Cable

Removing the SCSI Cable

1. Remove the hard disk drive.
See Section "Removing the Hard Disk Drive" on page 9-92.
2. Disconnect the SCSI cable from the I/O board.
FIGURE 8-4
72 SPARCstation Voyager Service Manual • December 1994
.
.
.
I/O board
Disconnecting the SCSI Cable from the I/O Board
SCSI cable